Hello Howard,

in my last message (see below) the question was not wether is an entry starting with a blank line or not or what is a correct ldif. My question was if back_perl is only accepting "ldif-like" entries starting with dn-spec.

If I return an entry like this:

version: 1 dn: ou=foo,dc=bar ou: foo objectClass: organizationalUnit objectClass: top description: users from foo

or with SEP after version-spec

version: 1

dn: ou=foo,dc=bar ou: foo objectClass: organizationalUnit objectClass: top description: users from foo

then the debug output from slapd is: "str2entry: entry -1 has no dn"

That means that back_perl doesn't accept ldif files but only "ldif-like" entries without version-spec.

If this is intended than I suggest to explain this in the man page or at least in the example shipped with back_perl.

Thank You for Your attention.

Regards Uwe

Am Sonntag, den 06.04.2008, 12:41 -0700 schrieb Howard Chu:

Please do not email me directly unless you are a paying client of my company. This thread started on the ITS. It should remain on the ITS.

I already explained to you what the RFC spec says about valid LDIF. Valid LDIF does not start with an empty line. There is nothing further to explain.

Uwe Werler wrote:

...

Dear Howard,

after some testing again I determined that back_perl doesn't accept ldif_entries which are starting with an empty line. Then slapd tells me "str2entry: entry -1 has no dn".

Is this behavior correct? If so it will be good to explain in the man page or the example that an entry should start with a dn line and shouldn't contain any empty lines nor the version information at the first line.

I think that my mistake was to use sample code I've found like this:

sub search {

 my $this = shift;
 my($base, $scope, $deref, $sizeLim, $timeLim, $filterStr, $attrOnly, @attrs ) = @_;
 if (! defined($this->{'LDAP'})) {
     $ldap = Net::LDAP->new( 'localhost' ) ;
     $this->{'LDAP'} = $ldap;
 }
 $mesg=$this->{'LDAP'}->search(base=>$base,
		  scope=>$scope,
		  deref=>$deref,
		  sizelimit =>$sizeLim,
		  timelimit =>$timeLim,
		  filter =>$filterStr,
		  attrs=>  @attrs );

 my @list = ();


 foreach $entry ($mesg->all_entries) {

my $data; $LDIF = new IO::Scalar $data; $dump=Net::LDAP::LDIF->new($LDIF,"w"); $dump->write($entry); $LDIF->close; push @list,$data; } return ( 0 , @list);

}

Because the entries returned by Net::LDAP::LDIF are starting with a leading SEP it won't work as is in back_perl.

Thank You very much for Your attention.

Regards Uwe