Well I continue to read the documentation, however here are some observations: 1. Slapd is up and running all the time. 2. The service seems to go in a freeze mode for about 15 minutes or so and then responds again. 3. Once it starts responding and I attempt to change password (using self service password) it freezes again and does not respond for the next 15 minutes. 4. This behavior happens even when not attempting to change the password but just some basic searches using phpldapadmin. 5. The server is adequately providing the needed memory and computing resources so dont this that is causing the issue.

Further any suggestions on what front end admin tool should be used with openldap.

Thanks and Regards,

*Amit Dongaonkar*

On Fri, Sep 4, 2020 at 4:29 PM Quanah Gibson-Mount quanah@symas.com wrote:

--On Friday, September 4, 2020 5:12 PM -0400 Amit Dongaonkar amitd@nitssolutions.com wrote:

...

As for the installation from the deb I was not aware the ubuntu provides its own build.

After running the ldapwhoami the system takes some time to respond but eventually responds with "ldap_sasl_bind(SIMPLE): Can't contact LDAP server (-1)"

Sounds like either slapd is not running or you're attempting to connect in an invalid fashion. I'd suggest doing some reading on how to use the ldap client tools, how to start slapd, how to use and connect to slapd, etc.

Regards, Quanah

--

Quanah Gibson-Mount Product Architect Symas Corporation Packaged, certified, and supported LDAP solutions powered by OpenLDAP: http://www.symas.com