Hi Quanah

During the installation configure script was run like this

./configure --enable-bdb=no --enable-hdb=no --enable-ipv6=yes

I just added following option to enable all overlays

./configure --enable-bdb=no --enable-hdb=no --enable-ipv6=yes *--enable-overlays=yes*

Will this fix the problem?

Thanks Rahul

On Wed, Jul 1, 2020 at 1:38 PM Quanah Gibson-Mount quanah@symas.com wrote:

--On Wednesday, July 1, 2020 11:09 AM -0400 kumar rahul rahul2002mit@gmail.com wrote:

...

I am seeing following ERROR

I have no idea how your slapd was built, etc. But essentially the accesslog overlay must be loaded into slapd to be of use. It looks like at least some of the modules in your system are compiled statically, which is likely why you currently do not have a module{0} section for loading modules. You'll also have to verify where on disk the accesslog overlay exists so that the moduleload statement pulls from the right directory.

Regards, Quanah

--

Quanah Gibson-Mount Product Architect Symas Corporation Packaged, certified, and supported LDAP solutions powered by OpenLDAP: http://www.symas.com